Skip to main content

NWCG Standards for M-2002 Fire Shelters: Selecting Your Deployment Site

The characteristics of an effective deployment site have not changed. Your goal in selecting a deployment site is to keep the fire shelter away from heat, especially flames. Practice evaluating deployment sites so that you can recognize them quickly under stress. Identify effective sites whenever you are on the fireline so you know where they are before you need one.

A rocky mountain forest

1. Keep away from narrow draws, chutes, and chimneys. They tend to funnel smoke, flames, and hot gases that can damage your shelter.

A rocky mountain forest

2. Avoid saddles on ridgetops. They also funnel smoke and heat.


A dirt road in through wildland forest.

3. Flat areas on slopes, such as benches, or road cuts, offer some protection from radiant and convective heat. These level areas can keep you below the path of flame and convective heat. Do not deploy in the middle of a road if vehicles may be passing. A drainage ditch on the uphill side of a road cut can be an effective deployment site unless it contains fuels that could ignite and burn the shelter. Four firefighters deployed their fire shelters on this road during a burnover. All four survived with only minor burns.

A rocky mountain forest

4. Stay out of draws, even when deploying on a road.


Birds eye view of a smoke rising above trees in a forest
A rockslide with tall trees in the forefront
A rocky mountain forest.
5. Try to pick natural firebreaks such as wet meadows, wide streambeds, swampy areas, and rockslides.


A rocky mountain forest
A rocky mountain forest
6. Do not deploy in or next to tall or thick grass, small trees, trees with low branches, brush, piles of slash, or firefighting equipment such as packs, parachutes, tools, or chain saws. Firefighters have been burned because they deployed too close to such fuels. Large rockslides can be effective deployment sites, but you must stay away from brush and trees, and from fuels scattered in the rocks. Even though it can be difficult to hold the edges of the shelter down, large, jumbled rocks, rockslides sometimes offer the largest area free of fuels and may be the best option for deployment.


A rocky mountain forest

7. Ground fuels, such as grass, or tree litter, can ignite rapidly. Clear the deployment site to mineral soil if time allows. If time is critical, pick a site with the sparsest fuels.

A rocky mountain forest

8. Deploy fire shelters well away from thick vegetation such as the shrubby understory and trees.


A rocky mountain forest

9. Boulders, large rocks, buildings, vehicles, and equipment can provide buffers from the heat of the fire. Keep in mind that when vehicles, equipment, and buildings catch fire, they burn hot, and for a much longer duration than the vegetation around them. This can lead to shelters being exposed to heat for a prolonged period, well after the flame front has passed. This may keep firefighters in their shelters longer, exposed to prolonged levels of dangerous heat.

A rocky mountain forest

10. Avoid areas where rocks or logs can roll on you or snags can fall on you.


A rocky mountain forest

11. The lee side of a ridgetop can be an effective deployment site because the flames and hot gases tend to rise above the ridge. Fire intensity usually drops when fire reaches a ridge. But be alert for the possibility that firebrands might ignite fires below you on the lee side of the ridge.

A rocky mountain forest

12. Burned-out areas can be effective deployment sites if there is no fuel left to reburn. Be aware of residual heat and hotspots on the ground. Scrape the ground if possible to clear away any heat and burning materials. Burn injuries have occurred from firefighters deploying in the black that was still hot.


A rocky mountain forest
A rocky mountain forest
13. Wide areas that have been cleared of fuel, such as dozer lines or roads, can be good deployment sites, depending on the size of the area that has been cleared and the behavior of the fire.

 

A rocky mountain forest
A rocky mountain forest
14. Bodies of water can be adequate deployment zones, however you should be aware of several hazards if you find yourself having to use a body of water. Deployments can last from several minutes to an hour or more. If the water is over your head in depth, you may be at higher risk of drowning especially once your boots and clothing become waterlogged. Since water removes heat from the body much faster than air, you may be at risk of hypothermia from deployments in bodies of water. If there is a current to the water your fire shelter may be hard to hold on to or you may become entangled in your shelter and drown. The fire shelter’s ends can fill with water and become very heavy. For further information read this tech tip on deploying in bodies of water.

 

 

Share on Social Media

NWCG Latest Announcements

NEW! S-390, Introduction to Wildland Fire Behavior Calculations (Blended) Available Now

Date: December 22, 2025
Questions about RT-130? 
Please contact: Fire Behavior Subcommittee

NWCG is excited to announce that the new S-390, Introduction to Wildland Fire Behavior Calculations (Blended) training is now available on the Wildland Fire Learning Portal.

This third course in the series combines online and instructor-led training components aimed at individuals who are involved in planning, managing, and executing wildland fire and prescribed burn operations; who require a thorough understanding of fire behavior calculations to enhance effectiveness and safety. This includes students who require the knowledge and skill necessary to perform the duties of a Type 3 Incident Commander (ICT3), Division/Group Supervisor (DIVS), or Prescribed Fire Burn Boss Type 2 (RXB2).

Students are required to be qualified as any Single Resource Boss position and complete the prerequisite S-290, Intermediate Wildland Fire behavior (Blended) course, before enrolling in S-390.

References:

S-390, Introduction to Wildland Fire Behavior Calculations (Blended)

Wildland Fire Learning Portal

NEW! S-320, Introduction to Incident Management Teams (Blended) Available Now

Date: December 18, 2025
Questions about RT-130? 
Please contact: Incident and Position Standards Committee

NWCG is excited to announce that S-320, Introduction to Incident Management Teams (Blended) is now available on the Wildland Fire Learning Portal!

This blended course combines online learning with instructor-led training, designed for individuals seeking to build leadership skills and gain experience in incident management.

Students are required to complete the prerequisite trainings ICS-100, Introduction to Incident Command System (ICS), ICS-200, Basic ICS for Initial Response, and ICS-700, An Introduction to the National Incident Management System (NIMS) prior to attending S-320.

References:

S-320, Introduction to Incident Management Teams (Blended)

Wildland Fire Learning Portal

New! Ransom Road WFSTAR Module

Date: December 16, 2025
Questions about RT-130? 
Please contact: NWCG Audiovisual Specialist

NWCG is excited to announce the release of the new Ransom Road Fire Module to RT-130, Wildland Fire Safety Training Annual Refresher (WFSTAR).

This module features a firsthand account from Rob Lee, official reports, and animated maps of the Ransom Road Fire which occurred on June 8, 1981, in Florida's Merritt Island National Wildlife Refuge.

The module is available now in NWCG's RT-130, WFSTAR Catalog.

References:

WFSTAR Catalog

Wildland Fire Lessons Learned Center

Call for Nominations: Paul Gleason Lead by Example Award

Date: December 11, 2025
Questions? Please contact:
 Leadership Committee 

Do you know someone working in wildland fire who strives to make positive change and is undeterred by obstacles or setbacks? Now is your chance to give that person the acknowledgment they deserve by nominating them for a Paul Gleason Lead by Example Award.

This award, is presented by the NWCG Leadership Committee to remember Paul Gleason's contributions to the wildland fire community and to recognize individuals or groups that exhibit the same spirit and dedication to leadership – those who lead by example.

Nominations can be submitted via email with an attached Lead by Example Form to BLM_FA_Leadership_Feedback@blm.gov or through the online form

Tips for successful nominations and more information can be found on the Lead by Example webpage. All nominations must be submitted by December 31, 2025.

References:

Paul Gleason Lead By Example Award 

Paul Gleason Lead by Example Award Nomination Form 2025 

Leadership Committee