Skip to main content

PMS 448

PMS 448

PMS 448

Introduction

COVID-19 Refurb Guidelines

References

All Content

Aviation

Camp

Clothing

Cordura

Fuel Handling

Kits

Medical

Miscellaneous

PPE

Small Engine Equipment

Tools

Water Handling

Deleted Items

Ladder – Step, 8’ Fiberglass

NFES #
000586
Category
Camp
Updated
Storage and Shelf Life Checks
Yes
Storage and Shelf Life Procedure
If stored upright, it must be securely strapped to prevent falling.

Initial Inspection/Disposal Criteria

  1. Ladders should not have any damage including cracks, chips and splinters, deformed rails or rungs from heat, chemical or environmental exposure, or any bends and breaks, lack of structural integrity, missing components or loose parts.
  2. The steps or rungs must be tight and secure to the side rails.
  3. All hardware and fittings need to be properly and securely attached.
  4. Movable parts must be tested to see that they operate without binding or without too much free play.
  5. All labels should be intact and readable.
  6. Ladders shall be free of oil, grease, or slippery materials.
  7. All accessories such as leg levelers, paint shelves, stand-off shelves, etc. are in good condition.
  8. The ladder feet must have slip resistant materials.
  9. Return to stock if ladder passes visual inspection and no refurbishment is needed.
  10. Refurbish if damage detected is repairable and cost effective.
  11. Dispose of any ladder that has any material defect or damage that cannot be repaired, excessive paint exists. Dispose of any wooden or metal ladders.

Refurbishing Procedures

A. Cleaning

  1. Remove all oil, grease.
  2. Clean with soap and water or power wash.
  3. Air dry.

B. Repair

  • Replace any damaged or missing components with manufacturer’s specific parts and meeting the ladder’s original design criteria.

C. Testing for performance

  1. Visual inspection of all ladder steps, ladder legs, and ladder cross supports.
  2. Set up ladder and check for stability.

D. Repackaging

  • Local cache option

 

Print PDF

NWCG Latest Announcements

NEW! NWCG Wildland Urban Interface Mitigation Field Guide, PMS 053

Date: March 12, 2025
Contact: Wildland Urban Interface Mitigation Committee

The NWCG Wildland Urban Interface Mitigation Field Guide, PMS 053 provides mitigation practitioners at all experience levels with recommendations on the most effective and efficient ways to accomplish mitigation work in communities at risk to wildfire damage or destruction. The content in this guide was written in coordination with the NWCG Standards for Mitigation in the Wildland Urban Interface, PMS 052.

References:

NWCG Wildland Urban Interface Mitigation Field Guide, PMS 053 

Updated, NWCG Standards for Wildland Fire Module Operations, PMS 430

Date: March 11, 2025
Contact: Fire Use Subcommittee
Wildland Fire Module Unit

The NWCG Standards for Wildland Fire Module Operations, PMS 430 standardizes procedures and expectations for Wildland Fire Modules (WFMs). These standards are to be used by staff, supervisors, specialists, and technicians for planning, administering, and conducting WFM operations. These standards will also be used as a measure of WFM qualifications, capabilities, and expected performance, for both Type 1 and Type 2 WFMs.

References:

NWCG Standards for Wildland Fire Module Operations, PMS 430

NEW! NWCG Standards for Airtanker Operations, PMS 514

Date: March 7, 2025
Contact: National Interagency Aviation Committee

The NWCG Standards for Airtanker Operations, PMS 514 establishes the standards for dispatching, utilizing, and coordinating airtankers on interagency wildland fires. These standards should be used in conjunction with the NWCG Standards for Aerial Supervision (SAS), PMS 505, NWCG Standards for Airtanker Base Operations (SABO), PMS 508, and any applicable agency plans.

References:

NWCG Standards for Airtanker Operations, PMS 514

Incident Position Standards and Next Gen Position Task Books Now Available for Dispatch Incident Positions

Date: March 5, 2025
Contact: National Coordination System Committee

NWCG is excited to announce that Incident Position Standards and Next Generation Position Task Books are now available for all six Dispatch positions:

  • Aircraft Dispatcher
  • Expanded Dispatch Coordinator
  • Expanded Dispatch Recorder
  • Expanded Dispatch Supervisory Dispatcher
  • Expanded Dispatch Support Dispatcher
  • Initial Attack Dispatcher

The Performance Support Packages for these positions, including the Expanded Dispatch Job Aid, J-601 and the Initial Attack and Aircraft Dispatcher Job Aid, J-602, were developed as part of the Incident Performance and Training Modernization (IPTM) effort. These resources support trainees, qualified personnel, and evaluators in their roles.

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1.

References:

NWCG Aircraft Dispatcher Position Page 

NWCG Expanded Dispatch Coordinator Position Page 

NWCG Expanded Dispatch Recorder Position Page 

NWCG Expanded Dispatch Supervisory Dispatcher Position Page 

NWCG Expanded Dispatch Support Dispatcher Position Page 

NWCG Initial Attack Dispatcher Position Page 

NWCG Job Aids