Skip to main content

PMS 448

PMS 448

Introduction

COVID-19 Refurb Guidelines

References

All Content

Aviation

Camp

Clothing

Cordura

Fuel Handling

Kits

Medical

Miscellaneous

PPE

Small Engine Equipment

Tools

Water Handling

Deleted Items

Waterbag - 5 gl, suppression, M2015

NFES #
000908
Category
Water Handling
Updated
Storage and Shelf Life Checks
None

Initial Inspection/Disposal Criteria    

  1. Inspect vinyl, fabric, and webbing for any holes, cuts, tears, burns, or torn seams that are not economically repairable, if any dispose of.
  2. Inspect plastic cap and fittings for cracks, breaks, missing gaskets or other damage.
  3. If bag appears to be used, inflate bag with air (<10 psi), submerge in water and check for leaks.  Dry vinyl and mark holes with black marker for patching in repair process.
  4. Inspect for any missing fasteners or that does not provide adequate closure.
  5. Inspect for excessive dirt or fuel stains that cleaning cannot eliminate, dispose of.
  6. Inspect for any writings, drawings. Dispose of if cleaning cannot remove markings.
  7. Return to stock if item does not show any signs of use and passes visual inspection.
  8. Refurbish if damage detected is repairable.
  9. Dispose of item if unable to repair.

Refurbishing Procedures

A. Cleaning

  1. Remove straps and clean exterior of bag thoroughly with filler cap attached.
  2. Support or hang bag, remove cap and fill with water to rinse out tank.
  3. Replace cap and shake bag vigorously until all foreign matter is removed.
  4. Drain completely.
  5. Invert bag after removing cap and empty as much water as possible.
  6. Let dry inverted for 1 hour in sun, if possible.
  7. Clean the straps with mild detergent and stiff bristle brush, machine launder, or gently pressure wash. Hang to dry.

B. Repair

  1. Patch any hole or tears.  No more than 3 patches should be present on the bag.  If more, dispose of bag.  Small pin hole can be repaired with TEAR-AID® Type B or other similar material recommended by the tank manufacturer.
  2. Larger holes can be repaired utilizing vinyl welding tools and techniques if available.
  3. Holes in the seams may not be repairable.
  4. Place patch on damaged area and apply pressure with roller or suitable device for at least 1 minute.
  5. The filler neck and cap can be replaced following the instructions included in the Fedco Bag Filler Neck Service Kit, part #181874.
  6. Repair or replace any damaged components on bag or straps.
  7. Ensure bags are stenciled with “non-potable” or “suppression use only.”

C. Testing for Performance

  1. Re-inspect any patches or repairs.
  2. Fill with air (<10 psi).  Spray patched area with soapy water and inspect for leaks.

D. Repackaging

  1. 8 each in NFES 002006 carton (23” x 19” x 10”)

 

Reference

Water Handling Equipment Guide, PMS 447-1 

 

Print PDF

NWCG Latest Announcements

Updated, NWCG Standards for Wildland Fire Module Operations, PMS 430

Date: March 11, 2025
Contact: Fire Use Subcommittee
Wildland Fire Module Unit

The NWCG Standards for Wildland Fire Module Operations, PMS 430 standardizes procedures and expectations for Wildland Fire Modules (WFMs). These standards are to be used by staff, supervisors, specialists, and technicians for planning, administering, and conducting WFM operations. These standards will also be used as a measure of WFM qualifications, capabilities, and expected performance, for both Type 1 and Type 2 WFMs.

References:

NWCG Standards for Wildland Fire Module Operations, PMS 430

NEW! NWCG Standards for Airtanker Operations, PMS 514

Date: March 7, 2025
Contact: National Interagency Aviation Committee

The NWCG Standards for Airtanker Operations, PMS 514 establishes the standards for dispatching, utilizing, and coordinating airtankers on interagency wildland fires. These standards should be used in conjunction with the NWCG Standards for Aerial Supervision (SAS), PMS 505, NWCG Standards for Airtanker Base Operations (SABO), PMS 508, and any applicable agency plans.

References:

NWCG Standards for Airtanker Operations, PMS 514

Incident Position Standards and Next Gen Position Task Books Now Available for Dispatch Incident Positions

Date: March 5, 2025
Contact: National Coordination System Committee

NWCG is excited to announce that Incident Position Standards and Next Generation Position Task Books are now available for all six Dispatch positions:

  • Aircraft Dispatcher
  • Expanded Dispatch Coordinator
  • Expanded Dispatch Recorder
  • Expanded Dispatch Supervisory Dispatcher
  • Expanded Dispatch Support Dispatcher
  • Initial Attack Dispatcher

The Performance Support Packages for these positions, including the Expanded Dispatch Job Aid, J-601 and the Initial Attack and Aircraft Dispatcher Job Aid, J-602, were developed as part of the Incident Performance and Training Modernization (IPTM) effort. These resources support trainees, qualified personnel, and evaluators in their roles.

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1.

References:

NWCG Aircraft Dispatcher Position Page 

NWCG Expanded Dispatch Coordinator Position Page 

NWCG Expanded Dispatch Recorder Position Page 

NWCG Expanded Dispatch Supervisory Dispatcher Position Page 

NWCG Expanded Dispatch Support Dispatcher Position Page 

NWCG Initial Attack Dispatcher Position Page 

NWCG Job Aids 

Incident Position Standards and the Next Generation Position Task Books Now Available for DMOB, DOCL, and RESL

Date: February 28, 2025
Contact: Incident Operations Subcommittee

NWCG is excited to announce that Incident Position Standards and the Next Generation Position Task Books are now available for Demobilization Unit Leader (DMOB), Documentation Unit Leader (DOCL), and Resources Unit Leader (RESL).

The Performance Support Packages for these positions, including a job aid for RESL, were developed as part of the Incident Performance and Training Modernization (IPTM) effort. These resources support trainees, qualified personnel, and evaluators in their respective roles.

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1.

References:

NWCG Demobilization Unit Leader Position Page 

NWCG Documentation Unit Leader Position Page 

NWCG Resources Unit Leader Position Page